Summer Starts Here - Save up to 70%
Trailer Wiring Harness Installation - 2006 Pontiac Montana- Video
Today in our 2006 Pontiac Montana, were going to install the toe ready T1 connector part number 118396. First well access the rear cargo area then were going to remove the two torch fit screws holding on the tail light for each sides, after we remove the hardware, well gently pull the tail light and assembly away from the body of the vehicle. As you can see this will allow us access to the tail light wiring harness. The tail like wiring connector will match the new T1 connector so well simply disconnect the manufactures wiring and plug the new T1 connector in line with the manufacturers. Once we get them snap into place, were going to go ahead and take the rest of our remaining wire and fit it down between the bumper cover and the sheet metal of the vehicle. Once we get all our wires fit underneath, just simply go ahead and reinstall the driver side tail light assembly. more
4/17/2012 11:24:02 AM
Trailer Wiring Harness Installation - 2006 Pontiac Montana 118396- Video
Today on this 2006 Pontiac Montana we are going to be installing wiring harness part number 118396. We are at the rear of the vehicle, with the cargo door open, and we want to go ahead and locate the port that our wiring harness is going to be plugging into. The ports are located directly behind the taillight on both the driver and passenger side. So the first thing that we want to go ahead and do is remove both taillight assemblies. Holding the taillight in place on the inboard side are two torque headed bolts. We need to go ahead and take those out. 0:38 more
8/4/2010 7:39:24 AM
Filter Videos
Filter Videos
